DTC Confirmation Procedure
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester, on a level road.
NOTE:
Check to make sure that the following conditions are satisfied when using this "DTC Confirmation Procedure".
- The following DTCs are not detected: DTCs related to MAF sensor and ECT sensor (other than P0125).
- Engine coolant temperature at engine start: 10 °C (50 °F) or less.
- With ignition switch OFF, connect scan tool.
- Turn ON ignition switch and clear DTC by using scan tool.
- Drive vehicle more than 37 mph (60 km/h) for 5 min. or more.
- Stop vehicle.
- Check DTC and pending DTC.