LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2008 >> SX4 LE, Standard >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine General Information And Diagnosis >> Diagnostic Information and Procedures >> DTC P0116: Engine Coolant Temperature Circuit Range / Performance >> DTC Confirmation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Confirmation Procedure

WARNING:
  • When performing a road test, select a place where there is no traffic or possibility of a traffic accident and very careful during testing to avoid occurrence of an accident.
  • Road test should be carried out with 2 persons, a driver and a tester, on a level road.
NOTE: Check to make sure that the following conditions are satisfied when using this "DTC Confirmation Procedure".
EVAP leak check model:
  • The following DTCs are not detected: DTCs related to MAF sensor and ECT sensor (other than DTC P0116)

    Non-EVAP-leak-check model:

  • Intake air temperature at engine start: -10 °C (14 °F) to 80 °C (176 °F)
  • Intake air temperature: -10 °C (14 °F) to 70 °C (158 °F)
  • Altitude (barometric pressure): 2400 m, 8000 ft or less (560 mmHg, 75 kPa or more)
  • The following DTCs are not detected: DTCs related to MAF sensor, ECT sensor (other than P0116), IAT sensor and barometric pressure sensor
  1. With ignition switch OFF, connect scan tool.
  2. Turn ON ignition switch, clear DTC.
  3. Drive vehicle more than 40 mph (65 km/h) for more than 12 minutes.
  4. Stop vehicle.
  5. Check DTC and pending DTC.
scientia non olet · About LEMON Manuals