Engine - Charging System

Water Pump and Generator Drive Belt Removal and Installation

Removal

WARNING: Disconnect negative (-) cable at battery before removing and installing generator belt.

1. Hoist vehicle.
2. Remove right side engine under cover.
3. Loosen tensioner by turning the tensioner pulley (2) clockwise.




4. While holding the tensioner and belt loose, remove generator belt (1).

Installation
1. Loosen tensioner by turning the tensioner pulley (2) clockwise.
2. While holding the tensioner, install generator belt (1).




3. Install right side engine under cover.

NOTE:
- Make sure that the belt fits each pulley's groove properly.
- After installing generator belt, make sure that tension indicator is within standard range referring to Water Pump and Generator Drive Belt On-Vehicle Inspection.