DTC Confirmation Procedure
NOTE:
Check to make sure that the following conditions are satisfied when using this "DTC Confirmation Procedure".
- Engine coolant temperature at engine start: lower than 20 °C (68 °F).
Other than MEXICO model:
- The following DTCs are not detected: MAF sensor, CMP sensor, CKP censor and ECT sensor (other than P0125).
MEXICO model:
- The following DTCs are not detected: MAF sensor, CMP sensor and ECT sensor (other than P0125).
- With ignition switch OFF, connect scan tool.
- Turn ON ignition switch and clear DTC by using scan tool if any.
- Start engine and run it for 10 min.
- Check DTC and pending DTC by using scan tool.