Select Cable Adjustment
- Remove manual selector, refer to MANUAL SELECTOR ASSEMBLY REMOVAL AND INSTALLATION with select cable connected.
- Loosen manual select cable end nut (1).
- Shift select lever (2) and manual select lever (3) to "N".
- Tighten manual select cable end nut (1) to specified torque.
Tightening torque
Manual select cable end nut a: 13 N.m (1.3 kg-m, 9.5 lb-ft)
- After select cable was installed, check for the following.
- Push vehicle with selector lever shifted to "P". Vehicle should not move.
- Vehicle can not be driven in "N".
- Vehicle can be driven in "D", "4" and "L".
- Vehicle can be backed in "R".