ATEQ TPMS Reset Procedure

NOTE: When the wheels have been rotated, or a tire pressure sensor has been replaced, retrain tire pressure sensor.

NOTE: When the tire pressure warning light illuminates and warning message appears on DIC, check air pressure of all tires and adjust to the specified pressure.

NOTE: The DIC will display the "SERVICE TIRE MONITOR" message if one or more of the tire pressure sensors has malfunctioned or if all of the sensors have not been programmed successfully. If warning indicators are still on, there is a problem in the TPMS. See appropriate manufacturer service information.

NOTE: The learn mode will cancel if the ignition is cycled to OFF or if more than 2 minutes has elapsed for any sensor that has not been learned. If the learn mode is cancelled before the first sensor is learned, the original sensor IDs will be maintained. If the learn mode is canceled for any reason after the first sensor is learned, all IDs are erased from the RCDLR memory and if equipped, the DIC will display dashes for tire pressures.

NOTE: Stray signals from other TPM equipped vehicles just driving by can be inadvertantly learned. If any random horn chirps are heard from the vehicle while performing the learn procedure, most likely a stray sensor has been learned and the procedure will need to be cancelled and repeated. Under these circumstances, performing the TPM Learn Procedure away from other vehicles would be highly recommended. In the event a particular sensor activation does not cause the horn to chirp, it may be necessary to rotate the wheel valve stem to a different position due to the sensor signal is being blocked by another component. Before proceeding with the steps below, verify the following: No other sensor learn procedure is being performed simultaneously within close proximity. Tire pressures are not being adjusted on another TPM equipped vehicle within close proximity. Park Brake and Headlamp Switch input parameters are functioning correctly.

Turn ON the ignition, with the engine OFF.
Apply the parking brake.
Set the tire pressure of all wheels to pressure specified on the tire and loading information label.
For vehicles with DIC buttons, press the vehicle information button until the RELEARN TIRE POSITIONS message displays. Then press the select/reset button. The horn will sound twice to indicate the receiver is ready, and the TIRE LEARNING ACTIVE message will display.
For vehicles that do not have DIC buttons, press the trip odometer reset stem until the RELEARN TIRE POSITIONS message displays. Then press and hold the trip odometer reset stem until the horn sounds twice and the TIRE LEARNING ACTIVE message displays.
Alternate method (with keyless entry). Simultaneously press the lock and unlock buttons on the transmitter until a horn chirp sounds. The horn sound indicates that the learn mode is enabled.
Starting with the Left Front tire, hold the TPMS3 against the side wall of the tire, within 3 inches of the valve stem. Press TEST button and wait for a horn chirp.
After the horn chirp has sounded, repeat procedure for the remaining 3 sensors in the following order: Right Front, Right Rear, Left Rear.
After the Left Rear sensor has been learned, a horn chirp will sound indicating all sensors have been learned.
Turn OFF the ignition to exit the learn mode.