Rear Output Shaft Housing Disassembly
WARNING: This page is about a different variant/trim than selected.
CALLOUT AND COMPONENT NAME TABLE
| Callout | Component Name |
|---|---|
| 1 | Transfer Case Rear Output Drive Gear Nut Tip: Use a 30 mm socket or J 29873. Special Tools J-08614-A Pinion Flange Holder and Remover |
| 2 | Transfer Case Rear Output Shaft Flange Special Tools DT-48146 Press Support |
| 3 | Transfer Case Rear Output Shaft Bearing Assembly Tip: Use a press to remove the output shaft from the housing. |
| 4 | Transfer Case Rear Output Shaft Bearing Spacer |
| 5 | Transfer Case Rear Output Shaft |
| 6 | Transfer Case Rear Output Shaft Oil Slinger Tip: Remove the slinger only if damaged. Refer to REAR OUTPUT DRIVE HOUSING CLEANING AND INSPECTION . |
| 7 | Transfer Case Rear Output Shaft Seal Tip: Discard the seal after removal. |