Output Gear Assembly Removal

Reference: LOW AND REVERSE CLUTCH PISTON REMOVAL .

Fig 1: Identifying Output Gear Retaining Ring & Output Gear Assembly

Courtesy of SUZUKI OF AMERICA CORP.

1. Rotate the transmission assembly so the I.D. tag is facing up.
2. Remove the output gear retaining ring (48) from the output gear assembly (12).
   Fig 2: Identifying Output Gear Assembly

   Courtesy of SUZUKI OF AMERICA CORP.
3. Remove the output gear assembly (12) from the transmission case assembly.
   NOTE: Do not disassemble the output drive gear.
4. Clean the output gear in solvent and air dry. Ensure the solvent is removed from the bearing.
5. Inspect the bearings feel for roughness or noise.
6. Inspect the gear teeth for:
   • Excessive wear
   • Chips or broken teeth
   • Metal embedded in the teeth
7. Replace the output drive gear as an assembly if any of the above conditions are found.

Reference: FRONT DIFFERENTIAL BEARING RACE AND SELECTIVE SHIM REMOVAL .

Reference: MANUAL SHIFT SHAFT SEAL AND BEARING REMOVAL .

Reference: FRONT WHEEL DRIVE SHAFT OIL SEAL REMOVAL .

Reference: FRONT DIFFERENTIAL CARRIER SEAL REMOVAL .

Reference: TRANSMISSION CASE INSPECTION .