Installation Procedure

Insert a new transaxle cooler line seal into the case bore.

Fig 1: Identifying Nub Of J 41239-1A
Courtesy of SUZUKI OF AMERICA CORP.
Remove the nub from the J 41239-1A.

Fig 2: Installing Nub Of J 41239-1A On Transaxle Cooler Line Seal
Courtesy of SUZUKI OF AMERICA CORP.
Install the nub of the J 41239-1A on the transaxle cooler line seal.
Tap the new transaxle cooler line seal into the case bore.

Fig 3: Identifying Transaxle Oil Cooler Line Assembly
Courtesy of SUZUKI OF AMERICA CORP.
Install the transaxle oil cooler line assembly to the transaxle.
CAUTION: Refer to FASTENER NOTICE .
Install the transaxle oil cooler line assembly nut.
Tightening torque

Tighten the transaxle cooler line retaining nut to 7 N.m (62 lb in) .
Lower the vehicle.
NOTE: Dexron®III automatic transmission fluid is not compatible with this transaxle. If Dexron®III ATF is used, transaxle failure will result. This transaxle uses GM T-IV fluid P/N 88900925.
Add fluid to the transaxle. Refer to TRANSMISSION FLUID CHECK procedure located in this article.
Start the engine and check for leaks.