Transmission Fluid Cooler Flushing and Flow Test: Clean-up

Fig 1: Identifying Main Function Switch At IDLE Position

Courtesy of SUZUKI OF AMERICA CORP.

1. Turn the main function switch to the IDLE position and allow the supply vessel pressure to dissipate.
2. Turn the main power switch to the OFF position.
3. Disconnect the supply and waste hoses and the 12-volt power source from the vehicle.
   NOTE: A small amount of water may drain from the bottom of the unit when the air supply is disconnected. This is a normal operation of the built-in water separator.
   Fig 2: Disconnecting Air Supply Hose From J 45096

   Courtesy of SUZUKI OF AMERICA CORP.
4. Disconnect the air supply hose from J 45096.
5. Dispose of the waste ATF in accordance with all applicable federal, state, and local requirements.
6. Clean the residual DEXRON®III from the transmission oil cooler, using compressed air to blow out the transmission oil cooler.