Installation Procedure

Position the control arm to the cradle/frame.

Fig 1: Identifying New Control Arm-To-Frame Rear Bolts & Nuts
Courtesy of SUZUKI OF AMERICA CORP.

CAUTION: Refer to FASTENER NOTICE .
Install new control arm-to-frame rear bolts and nuts.
Tightening torque

Tighten the control arm rear bolts and nuts to 70 N.m (52 lb ft) .

Fig 2: Identifying Control Arm-To-Frame Front Bolt & Nut
Courtesy of SUZUKI OF AMERICA CORP.
Install a new arm-to-frame front bolt and nut.
Install new control arm-to-frame rear bolts and nuts.

Tightening torque

Tighten the control arm front bolt and nut to 120 N.m (89 lb ft) .

Fig 3: Identifying Control Arm Ball Stud & Steering Knuckle
Courtesy of SUZUKI OF AMERICA CORP.
Position the control arm ball stud into the steering knuckle and install the nut.
Tightening torque

Tighten the nut to 40 N.m (30 lb ft) .

Fig 4: Identifying Joint Cotter Pin
Courtesy of SUZUKI OF AMERICA CORP.
NOTE:
- Do not loosen the castle nut, only tighten to align the ball stud slot.
- Ensure that the cotter pin ends do not contact the antilock brake system (ABS) sensor harness or drive axle.
Continue to tighten the nut only enough to align the castle nut slots with the ball stud, install a new cotter pin.
Install the wheel and tire assembly. Refer to INSTALLATION PROCEDURE .
Lower the vehicle.