Input Speed Sensor Replacement

Input Speed Sensor Replacement

Removal Procedure
1. Remove the battery tray.





2. Disconnect the electrical connector (4)from the input speed sensor.





3. Remove the input speed sensor bolt.
4. Remove the input speed sensor.
5. Remove the input speed sensor O-ring. Discard the O-ring.

Installation Procedure





1. Apply GM T-IV automatic transaxle fluid GM P/N 88900925 to the new input speed sensor O-ring.
2. Install the new input speed sensor O-ring onto the input speed sensor.
3. Install the input speed sensor to the transaxle.

CAUTION:
Refer to [Fastener Notice]

4. Install the input speed sensor bolt.
Tightening torque
Tighten the bolt to 6 Nm (53 in. lbs.).





5. Connect the electrical connector (4) to the input speed sensor.
6. Install the battery tray.