Ignition Coil Replacement - Bank 1
Ignition Coil Replacement - Bank 1Removal Procedure
1. Remove the fue8 injector sight shield. Refer to Fuel Injector Sight Shield Replacement.
2. Disconnect the engine wiring harness electrical connector(s) (1) from the ignition coil(s).
3. Remove the ignition coil bolt(s).
4. Remove the ignition coil(s).
Installation Procedure
1. Install the ignition coil(s).
CAUTION: Refer to Fastener Notice.
2. Install the ignition coil bolt(s).
Tightening torque
Tighten the bolt(s) to 10 N.m (89 in. lbs.).
3. Connect the engine wiring harness electrical connector(s) (1) to the ignition coil(s).
4. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement.