Clutch Grabbing

Checks	Actions
Inspect for a burned or a glazed facing caused by oil on the facing.	Correct the leak at its source and install a new clutch disc.
Inspect for worn splines on the input shaft.	Replace the worn input shaft.
Inspect for a warped pressure plate or a warped flywheel.	Replace the warped pressure plate or the warped flywheel.
Inspect for a burned or smeared resin on the flywheel or the pressure plate.	Sand off the burned or smeared resin if it is superficial. Replace any burned or heat-checked parts.
Hydraulic clutch actuator cylinder damaged or worn	Replace the release cylinder.