LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> Swift + >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Suspension System >> Repair Instructions >> Strut Assembly Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Strut Assembly-To-Body & Nut
    GM1241960Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the strut assembly into the vehicle with the strut assembly-to-body nuts and the washers.

    Tighten:  Tighten the strut assembly-to-body nuts to 60 N.m (44 lb ft).

    2. Fig 2: Brake Caliper, Knuckle/Strut Assembly & ABS Speed Sensor Electrical Connector
    GM1241961Courtesy of GENERAL MOTORS CORP.
  2. Install the strut to the knuckle.
  3. Install the nuts and the bolts to the strut.

    Tighten:  Tighten the nuts and the bolts to 100 N.m (74 lb ft).

  4. Remove the support from the drive axle.
  5. Connect the ABS speed sensor electrical connector, if equipped.
  6. Install the brake caliper to the knuckle. Refer to Brake Caliper Replacement .
  7. Install the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals