Installation Procedure

NOTE: Refer to Fastener Notice .

Fig 1: Power Steering Gear Rack/Pinion Assembly, Steering Gear Retaining Bracket & Nuts

Courtesy of GENERAL MOTORS CORP.

Install the rack and pinion assembly by connecting the steering gear retaining bracket nuts.
Tighten: Tighten the steering gear retaining bracket nuts to 50 N.m (37 lb ft).

Fig 2: Power Steering Gear Cross Member, Nuts, Bolts & Underbody

Courtesy of GENERAL MOTORS CORP.

Install the cross member by tightening the nuts and bolts to the underbody.
Tighten: Tighten the cross member by tightening the nuts and bolts to the underbody to 150 N.m (111 lb ft).

Fig 3: Separating The Steering Knuckle From The Lower Ball Joint Using KM-507-C

Courtesy of GENERAL MOTORS CORP.

Install the ball joint hex nuts and connect the stabilizer shaft to the knuckle by tightening the bolt with stabilizer shaft link assembly. Refer to Stabilizer Shaft Replacement .
Tighten:
- Tighten the ball joint hex nuts to knuckle to 45 N.m (33 lb ft).
- Tighten the bolts of stabilizer shaft to the knuckle to 45 N.m (33 lb ft).

Fig 4: Power Steering Gear Outer Tie Rod Hex Nuts

Courtesy of GENERAL MOTORS CORP.

Install the outer tie rod hex nuts.
Tighten: Tighten the outer tie rod hex nuts to 45 N.m (33 lb ft).
Install the front tires. Refer to Tire and Wheel Removal and Installation .

Fig 5: Power Steering Gear Intermediate Shaft

Courtesy of GENERAL MOTORS CORP.