Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Install the insulators to the stabilizer shaft.
Install the brackets to the stabilizer shaft insulators.

Fig 1: U-Clamp Bolts & Stabilizer Bar

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the bolts to the stabilizer shaft insulator brackets.
Tighten: Tighten the stabilizer shaft insulator bracket bolts to 25 N.m (18 lb ft).
Raise and install the front suspension crossmember. Refer to Front Suspension Crossmember Replacement .
Remove the jacks and lower the vehicle.