LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Front Suspension System) >> Diagnostic Information and Procedures >> Ball Stud and Knuckle Inspection >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Ball Stud and Knuckle Inspection: Notes

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the front of the vehicle to allow the front suspension to hang free.
    2. NOTE: Refer to Vehicle Lifting and Jacking Notice .
  2. Grasp the tire at the top and the bottom.
  3. Move the top of the tire in an in-and-out motion.
  4. Look for any horizontal movement of the knuckle relative to the control arm.
  5. Ball joints must be replaced under the following conditions:
    • The joint is loose.
    • The ball seal is cut.
    • The ball stud is disconnected from the knuckle.
    • The ball stud is loose at the knuckle.
    • The ball stud can be twisted in its socket with finger pressure.
scientia non olet · About LEMON Manuals