LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Wiring Systems And Power Management - Connector Terminal Repairs & Ignition Switch Troubleshooting) >> Repairing Connector Terminals >> Tools Required >> Repair
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Tools Required: Repair

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Some terminals do not require all of the steps shown. Skip the steps that do not apply for your immediate terminal repair. The J-38125  contains further information. See Special Tools .

  1. Cut off the terminal between the core and the insulation crimp. Minimize any wire loss.

    For Weather Pack® terminals, remove the seal.

  2. Apply the correct seal per gage size of the wire.

    For Weather Pack® terminals, slide the seal back along the wire in order to enable insulation removal.

  3. Remove the insulation.
  4. For Weather Pack® terminals only, align the seal with the end of the cable insulation.
  5. Position the strip in the terminal.

    For Weather Pack® terminals, position the strip and seal in the terminal.

  6. Hand crimp the core wings.
  7. Hand crimp the insulation wings.

    For Weather Pack® terminals, hand crimp the insulation wings around the seal and the cable.

  8. Solder all of the hand crimp terminals excepting Micro-Pack 100 World terminals. Soldering Micro-Pack 100 World terminals may damage the terminal.
scientia non olet · About LEMON Manuals