LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Thermal Expansion Valve Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Expansion Valve Connector Block & Retaining Bolts
    GM1251937Courtesy of GENERAL MOTORS CORP.
  1. Clean the O-ring surface areas of dirt or contamination.
  2. Install new O-rings on the evaporator tubes.
  3. Install a new expansion valve onto the evaporator tubes.
    4. NOTE: Refer to Fastener Notice .
  4. Install the expansion valve retaining bolts.

    Tighten:  Tighten the expansion valve retaining bolts to 12 N.m (106 lb in).

    5. Fig 2: Liquid Evaporator Pipe Connector Block & Retaining Nut
    GM1251935Courtesy of GENERAL MOTORS CORP.
  5. Install the liquid evaporator pipe connecting block retaining nut at the cowl.

    Tighten:  Tighten the liquid evaporator pipe connecting block retaining nut to 15 N.m (11 lb ft).

  6. Connect the negative battery cable.
  7. Evacuate and recharge the system. Refer to Refrigerant Recovery and Recharging .
scientia non olet · About LEMON Manuals