LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Front Drive Axle) >> Repair Instructions >> Wheel Drive Shaft Outer Joint and Boot Replacement (Automatic) >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Outer Joint And Axle Shaft Snap Ring
    GM1242026Courtesy of GENERAL MOTORS CORP.
  1. Install the seal onto the axle shaft.
  2. Spread the snap ring using the J 8059  and remove the outer joint and the axle shaft. See Special Tools .
  3. Fill the joint seal with 110-130 g (3.9-4.6 ounces) of the recommended grease. Repack the joint with 110-130 g (3.9-4.6 ounces) of the recommended grease.
    4. Fig 2: View Of Large Seal Retaining Clamp With J 35566
    GM1242025Courtesy of GENERAL MOTORS CORP.
  4. Install a new large seal retaining clamp and a new small seal retaining clamp.
  5. Crimp the new small seal retaining clamp and the new large seal retaining clamp using the J 35566  (1). See Special Tools .
  6. Install the drive axle shaft to the vehicle. Refer to Front Drive Axle Inner Shaft and Inner Shaft Housing Replacement .
scientia non olet · About LEMON Manuals