LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Rear Door Trim Panel Replacement (Hatchback) >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Trim Panel
    GM1248475Courtesy of GENERAL MOTORS CORP.
  1. Install the trim panel.
    2. NOTE: Refer to Fastener Notice .
  2. Install the screws at the base of the trim panel.

    Tighten:  Tighten the trim panel screws to 3.5 N.m (31 lb in).

    3. Fig 2: View of Rear Window Regulator, Door Pull Screw and Inside Door Handle
    GM1545027Courtesy of GENERAL MOTORS CORP.
  3. Install the rear door interior garnish molding.
  4. Install the inside door handle.
  5. Install the door pull screw.

    Tighten:  Tighten the door pull screw to 3.5 N.m (31 lb in).

  6. Install the rear window regulator handle. Refer to Door Window Regulator Handle Replacement .
  7. Raise the window.
scientia non olet · About LEMON Manuals