Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Tie Rod Lock Nuts & Outer Tie Rod

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the outer tie rod with the lock nuts.
Tighten: Tighten the lock nuts to 54 N.m (40 lb ft).

Fig 2: Outer Tie Rod Hex Nut & Steering Knuckle

Courtesy of GENERAL MOTORS CORP.

Install the outer tie rod with the hex nut.
Tighten: Tighten the hex nut to 45 N.m (33 lb ft).
Inspect the vehicle. Refer to Preliminary Alignment Inspection and Straight Ahead Inspection .
Measure the wheel alignment.
If necessary, adjust the front toe. Refer to Front Toe Adjustment .