Circuit/System Verification
WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON, observe the DTC information with a scan tool. Verify DTCs P0122, P0123, P0222, or P0223 should not set.
- If any of the DTCs are set refer to DTC P0122, P0123, P0222, P0223, or P2135 (w/TAC) or DTC P0122, P0123, P0222, P0223, or P2135 (wo/TAC) for further diagnosis.
- Ignition ON, observe the scan tool TP Sensor percentage parameters with a scan tool. Verify the scan tool TP sensor parameters are between 7-21 percent.
- If not within the specified range, refer to DTC P0122, P0123, P0222, P0223, or P2135 (w/TAC) or DTC P0122, P0123, P0222, P0223, or P2135 (wo/TAC) for further diagnosis.
- Rapidly depress the accelerator pedal from the rest position to the wide open throttle position (WOT) and release pedal. Repeat the procedure several times. DTCs P1516, P2101, or P2119 should not set.
- If DTCs P0122, P0123, P0222, P0223, or P2135 set while performing this procedure, refer to DTC P0122, P0123, P0222, P0223, or P2135 (w/TAC) or DTC P0122, P0123, P0222, P0223, or P2135 (wo/TAC) for further diagnosis.
- Slowly depress the accelerator pedal to WOT and then slowly return the pedal to closed throttle. Repeat the procedure several times. DTCs P1516, P2101, or P2119 should not set.
- If DTCs P0122, P0123, P0222, P0223, or P2135 set while performing this procedure, refer to DTC P0122, P0123, P0222, P0223, or P2135 (w/TAC) or DTC P0122, P0123, P0222, P0223, or P2135 (wo/TAC) for further diagnosis.
- Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.