Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Battery Tray

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the battery carrier by fastening the carrier tray upper and lower bolts.
Tighten: Tighten the battery carrier tray upper and the lower bolts to 20 N.m (15 lb ft).

Fig 2: View Of Battery

Courtesy of GENERAL MOTORS CORP.

Install the battery into the tray.
Fasten the bar clamp to the battery by loosely attaching the battery rods from the batter tray cutouts through the bar clamp holes, and loosely tightening the nuts.
Tighten: Tighten the battery retainer clamp-to-battery rod nuts to 4 N.m (35 lb in).
Connect the negative battery cables.
Tighten: Tighten the battery cable nuts to 4.5 N.m (40 lb in).