LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Engine Controls And Fuel - 1.6L - Introduction (2 Of 2)) >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Accelerator Pedal Retaining Nuts
    GM1670940Courtesy of GENERAL MOTORS CORP.
  1. Position the accelerator pedal.
    2. NOTE: Refer to Fastener Notice .
  2. Install the 3 accelerator pedal retaining nuts.

    Tighten:  Tighten the accelerator pedal retaining nuts to 19 N.m (14 lb ft).

  3. Connect the ETC connector to the accelerator pedal.
  4. Connect the negative battery cable.
scientia non olet · About LEMON Manuals