LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Drum Brake System) >> Repair Instructions >> Brake Drum Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Adjust the rear brakes. Refer to Drum Brake Adjustment .
    2. Fig 1: Rear Wheel Bearing/Hub Components
    GM1753792Courtesy of GENERAL MOTORS CORP.
  2. Install the brake drum (3) to the hub (7).
    3. NOTE: Refer to Fastener Notice .
  3. Install the screws (6) to the brake drum.

    Tighten:  Tighten the screws to 4 N.m (35 lb in).

  4. Install the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  5. Lower the vehicle.
    6. IMPORTANT: If the clicking sound of the adjuster is not audible from either brake drum, the clearance between the brake shoes and the brake drum is adjusted.
  6. Apply the brake pedal at least 10 times in order to adjust the clearance between the brake shoes and the brake drum.

    Verify the clicking sound of the adjuster assembly is not audible from either brake drum.

  7. Adjust the park brake. Refer to Park Brake Adjustment .
scientia non olet · About LEMON Manuals