Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Wheel Speed Sensor

Courtesy of GENERAL MOTORS CORP.

Install the rear wheel speed sensor, and install the cable grommets.

NOTE: Refer to Fastener Notice .

Install the rear wheel sensor mounting bolt.
Tighten: Tighten the bolt to 9 N.m (80 lb in).
Connect the electrical connector for the rear wheel speed sensor to the rear axle.
Lower the vehicle.
Connect the negative battery cable.