Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Front Bumper Fascia

Courtesy of GENERAL MOTORS CORP.

Install the bumper fascia.
Install the screws on the top of the fascia.

Fig 2: View of Screws Underneath Fascia

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the screws underneath the fascia.
Install the nuts behind the fascia.
Tighten: Tighten the front bumper impact beam nuts to 27 N.m (20 lb ft).
Install the screws in the wheel wells.
Tighten: Tighten the front wheel well screws to 1.5 N.m (13 lb in).
Install the headlamps, the turn signal lamp, the side turn signal lamps, and the front fog lamps.
Refer to Headlamp Replacement (Notchback) or Headlamp Replacement (Hatchback) , Front Side Marker Lamp Replacement and Front Fog Lamp Replacement (Notchback) or Front Fog Lamp Replacement (Hatchback) .

Fig 3: View of Screws, Bolts, Nuts, and Front Wheel Well Splash Shields

Courtesy of GENERAL MOTORS CORP.

Install the front wheel well splash shields with the screws, the bolts, and the nuts.
Tighten:
- Tighten the splash shield screws to 1.5 N.m (13 lb in).
- Tighten the splash shield bolts to 1.5 N.m (13 lb in).
- Tighten the splash shield nuts to 1.5 N.m (13 lb in).
Connect the negative battery cable.