LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Sensing and Diagnostic Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Sensing and Diagnostic Module
    GM1724853Courtesy of GENERAL MOTORS CORP.
  1. Install the SDM (3).
    2. CAUTION: Be careful when you handle a sensor. Do not strike or jolt a sensor. Before applying power to a sensor:
    • Remove any dirt, grease, etc. from the mounting surface.
    • Position the sensor horizontally on the mounting surface.
    • Point the arrow on the sensor toward the front of the vehicle.
    • Tighten all of the sensor fasteners and sensor bracket fasteners to the specified torque value.

    Failure to follow the correct procedure could cause air bag deployment, personal injury, or unnecessary SIR system repairs.
    NOTE: Refer to Fastener Notice .
  2. Install the SDM mounting bolts (1).

    Tighten:  Tighten the SDM mounting bolts to 10 N.m (89 lb in).

  3. Connect the SDM electrical connector (2).
  4. Install the connector position assurance lock, which is tethered to the SDM connector.
  5. Install the floor console trim bezel. Refer to Front Floor Console Replacement (Notchback) or Front Floor Console Replacement (Hatchback) .
  6. Enable the SIR. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals