Repair Verification

With Service Bay Test

Verify the EVAP system repair using the EVAP Service Bay Test

Without Service Bay Test

1. Turn the nitrogen/smoke valve to nitrogen.
IMPORTANT: The EVAP vent solenoid valve will not remain closed when commanded ON with positive pressure applied to the EVAP system.
2. Disconnect the EVAP vent line from the vent solenoid, and seal it, using the correct plug from the J 41413-300  . See Special Tools .
3. Use the remote switch to activate the J 41413-200  . See Special Tools .
4. Use the remote switch to introduce nitrogen and fill the EVAP system until the floating indicator stabilizes.
5. Verify the flow meter's stable floating indicator position is at or below the red flag.
6. Clear the DTCs with a scan tool.