Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the appropriate HO2S.
- Ignition ON, verify that a test lamp illuminates between the ignition 1 voltage circuit and ground.
- If the test lamp does not illuminate, test the ignition 1 voltage circuit for a short to ground or an open/high resistance. If the circuit tests normal and the ignition 1 voltage circuit fuse is open, test all components connected to the ignition 1 voltage circuit and replace as necessary.
- Ignition OFF, connect a test lamp between the control circuit and B+. The test lamp should not illuminate.
- If test lamp is always ON, test the control circuit for a short to ground. If the circuit/connections test normal, replace the ECM.
- Engine idling, verify the test lamp illuminates or flashes.
- If the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit/connections test normal, replace the ECM.
- If all circuits/connections test normal, test or replace the HO2S sensor.