LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> Swift + >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls & Fuel - 1.6L - DTC P0016 To P0317 >> DTC P0107 or P0108 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition OFF, disconnect the vacuum hose at the MAP sensor. Connect the J 23738-A  to the vacuum hose.
  2. Engine idling, verify that 15-20 in Hg of vacuum is available to the MAP sensor.
    • If the vacuum is not within the specified range, repair the restriction in the vacuum hose to the MAP sensor.
  3. Ignition OFF, connect the vacuum hose to the MAP sensor. Disconnect the harness connector at the MAP sensor.
  4. Ignition ON, test for less than 0.2 volt between the low reference circuit and ground.
    • If greater than the specified value, test the low reference circuit for a short to voltage. If the circuit/connections test normal, replace the ECM.
  5. Ignition OFF, test for less than 5 ohms of resistance between the low reference circuit and ground.
    • If greater than the specified value, test the low reference circuit for an open/high resistance. If the circuit/connections test normal, replace the ECM.
  6. Ignition ON, load test for 4.8-5.2 volts between the 5-volt reference circuit and ground.
    • If less than the specified range, test the 5-volt reference circuit for a short to ground or open/high resistance. If the circuit/connections test normal, replace the ECM.
    • If greater than the specified range, test the 5-volt reference circuit for a short to voltage. If the circuit/connections test normal, replace the ECM.
  7. Verify that the scan tool MAP sensor pressure parameter is less than 12 kPa.
    • If greater than the specified value, test the signal circuit for a short to voltage. If the circuit/connections test normal, replace the ECM.
  8. Install a 3A fused jumper wire between the signal circuit and the 5-volt reference circuit. Verify that the MAP sensor parameter is greater than 102 kPa.
    • If less than the specified value, test the signal circuit for a short to ground or an open/high resistance. If the circuit/connections test normal, replace the ECM.
  9. If all circuits/connections test normal, test or replace the MAP sensor.
scientia non olet · About LEMON Manuals