LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> Swift + >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System >> Repair Instructions >> Proportioning Valve Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of Master Cylinder Body Valves
    GM1245637Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Brake Fluid Caution .
    NOTE: Refer to Fastener Notice .
    IMPORTANT: Since these valves are adjusted in pairs to the correct control range, they must be replaced in pairs.
  1. Install the proportioning valves to the cylinder body.

    Tighten:  Tighten the proportioning valves to 35-44 N.m (26-33 lb ft).

  2. Connect the brake lines to the valves.

    Tighten:  Tighten the brake lines to 16 N.m (12 lb ft).

    3. NOTE: Refer to Vehicle Lifting and Jacking Notice .
  3. Raise and suitably support the vehicle.
  4. Bleed the braking system. Refer to Hydraulic Brake System Bleeding (Manual) .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals