LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> Swift + >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems & Power Management - 1 Of 9 >> Repair Instructions >> Ignition Lock Cylinder Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Key Hole Illumination
    GM1716070Courtesy of GENERAL MOTORS CORP.
  1. Complete the following steps in order to install the key hole illumination (1):
    1. Install the key hole illumination.
    2. Install the key hole illumination screw (2).
    3. Connect the key hole illumination connector.
    2. Fig 2: Ignition Switch
    GM1716033Courtesy of GENERAL MOTORS CORP.
  2. Complete the following steps in order to install the ignition switch (2):
    1. Install the ignition switch.
    2. Install the ignition switch screw (1).
    3. Connect the ignition switch connector.
    3. Fig 3: Ignition Lock Cylinder
    GM1716019Courtesy of GENERAL MOTORS CORP.
  3. Install the ignition lock cylinder (2).
  4. Remove the key.
    5. Fig 4: Key Reminder Switch
    GM1716043Courtesy of GENERAL MOTORS CORP.
  5. Complete the following steps in order to install the key reminder switch (3):
    1. Install the key reminder switch.
    2. Install the screws (1,2).
    3. Connect the key reminder switch connector.
    4. Install the steering wheel. Refer to Steering Wheel Replacement .
    6. Fig 5: Steering Column Panels
    GM1715979Courtesy of GENERAL MOTORS CORP.
  6. Install the lower steering column cover panel (5) and the screws (6, 7, 8).
  7. Connect the negative battery cable.
scientia non olet · About LEMON Manuals