Security Indicator Inoperative

Step	Action	Yes	No
Schematic Reference: Theft Deterrent System Schematics (Notchback) or Theft Deterrent System Schematics (Hatchback) Connector End View Reference: Theft Deterrent System Connector End Views (Notchback) or Theft Deterrent System Connector End Views (Hatchback) DEFINITION: The status of the security indicator never changes and the security indicator never illuminates.
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Turn OFF the ignition. Disconnect the remote control door lock receiver (RCDLR). Connect a 3-amp fused jumper wire between the security indicator control circuit and ground. Turn ON the ignition, with the engine OFF. Is the security indicator ON?	Go to Step 5	Go to Step 3
3	Test the security indicator control circuit for an open or high resistance. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition?	Go to Step 7	Go to Step 4
4	Replace the security indicator. Refer to Clock Replacement . Did you complete the replacement?	Go to Step 7	-
5	Test for a poor connection at the RCDLR. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition?	Go to Step 7	Go to Step 6
6	Replace the RCDLR. Refer to Remote Control Door Lock Receiver Replacement . Did you complete the replacement?	Go to Step 7	-
7	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2