Rear Window Glass Removal and Installation: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.

Install the new weatherstrip to the rear window.

Fig 1: Installing New Weatherstrip To Rear Window
Courtesy of SUZUKI OF AMERICA CORP.
Apply tape to the new weatherstrip and the rear window to hold the weatherstrip in place.
Apply adhesive primer to the rear window frame and the perimeter of the rear window.

Fig 2: Applying Adhesive Primer To Rear Window Frame And Perimeter Of Rear Window
Courtesy of SUZUKI OF AMERICA CORP.
Apply glass adhesive to the rear window frame.

Fig 3: Applying Glass Adhesive To Rear Window Frame
Courtesy of SUZUKI OF AMERICA CORP.
Install the rear window into the rear window frame.
Reposition the tape over the weatherstrip, the rear window, and the rear window frame to hold the rear window in place.
Let the adhesive dry for 24 hours.
Remove the tape.
Check for waterleaks by pouring water on the rear window. If a leak is found, dry the window and fill the area that leaks with adhesive. If the leak persists, remove the rear window and repeat the entire procedure.
Connect the rear window defogger electrical connector.
Install the C-pillar trim panel. Refer to C-PILLAR TRIM PANEL REMOVAL AND INSTALLATION .
Connect the negative battery cable.

Fig 4: Connecting Rear Window Defogger Electrical Connector
Courtesy of SUZUKI OF AMERICA CORP.