Rear Axle Removal and Installation (Rear Disc Brake Model): Installation

Reference: REAR AXLE AND COIL SPRING INSPECTION 

1. Install rubber edge covers (2) (if equipped) to rear axle (1) as shown in figure, if removed.
   Fig 1: Identifying Rear Axle And Rubber Edge Covers

   Courtesy of SUZUKI OF AMERICA CORP.
2. Install brake pipes to rear axle, if removed.
3. Place rear axle on floor jacks.

   Then install rear axle and new rear axle bolts (1) and tighten bolts temporarily.

   Fig 2: Identifying Rear Axle Bolts

   Courtesy of SUZUKI OF AMERICA CORP.
4. Install coil springs referring to REAR COIL SPRING REMOVAL AND INSTALLATION .
5. Install exhaust center pipe.
6. Install rear wheel hubs referring to Step  2) to  4) of "Installation" under REAR WHEEL HUB ASSEMBLY REMOVAL AND INSTALLATION (REAR DISC BRAKE MODEL) .
7. Install rear brake caliper, brake flexible hose and parking brake cable referring to REAR DISC BRAKE CALIPER REMOVAL AND INSTALLATION .
8. Install wheel speed sensor clamps (2) and tighten parking brake cable nuts (1) to specified torque.

   Tightening torque 

   Parking brake cable clamp bolt a: 26 N.m (2.6 kg-m, 19.0 lb-ft) 

   Fig 3: Identifying Wheel Speed Sensor Clamps And Parking Brake Cable Nuts

   Courtesy of SUZUKI OF AMERICA CORP.
9. Fill reservoir with brake fluid and bleed brake system. For bleeding operation, see AIR BLEEDING OF BRAKE SYSTEM .
10. Install wheel and tighten wheel nuts to specified torque.

    Tightening torque 

    Wheel nut: 85 N.m (8.5 kg-m, 61.5 lb-ft) 

11. Adjust parking brake cable. For adjustment, refer to PARKING BRAKE INSPECTION AND ADJUSTMENT .
12. Lower hoist and bounce vehicle up and down several times to stabilize suspension.
13. Tighten shock absorber lower nuts and rear axle bolts to specified torque.
    NOTE: When tightening these nuts and bolts, be sure that vehicle is not on hoist and in unloaded condition.

    Tightening torque 

    Rear shock absorber lower nut: 90 N.m (9.0 kg-m, 65.0 lb-ft) 

    Rear axle bolt: 73 N.m (7.3 kg-m, 53.0 lb-ft) 

14. Check foot brake and parking brake.
15. Check each installed part for fluid leakage.