LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Standard >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Air Bag System >> Advanced Air Bag >> Repair Instructions >> Enabling Air Bag System
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Enabling Air Bag System

  1. Confirm that battery negative (-) cable is disconnected.
  2. Turn ignition switch to "LOCK" position and remove key.
  3. Connect yellow connector (1) of driver air bag (inflator) module by pushing connector till click is heard from it.
    Fig 1: Connecting Yellow Connector Of Driver Air Bag (Inflator) Module
    G04848761Courtesy of SUZUKI OF AMERICA CORP.
  4. Connect yellow connector (1) of passenger air bag (inflator) module by pushing connector till click is heard from it.
    Fig 2: Connecting Yellow Connector Of Passenger Air Bag (Inflator) Module
    G04848762Courtesy of SUZUKI OF AMERICA CORP.
  5. Install driver and passenger side front pillar lower trim.
  6. Connect yellow connector (1) of side-air bag (inflator) module by pushing connector till click is heard from it.
    Fig 3: Connecting Yellow Connector Of Side-Air Bag (Inflator) Module
    G04848763Courtesy of SUZUKI OF AMERICA CORP.
  7. Connect yellow connector (1) of side curtain air bag (inflator) module by pushing connector till click is heard from it.
    Fig 4: Connecting Yellow Connector Of Side Curtain Air Bag (Inflator) Module
    G04848764Courtesy of SUZUKI OF AMERICA CORP.
  8. Install right-side rear quarter lower trim.
  9. Install "A/B" fuse to fuse box.
  10. Connect negative (-) cable at battery.
  11. Turn ignition switch to ON position and verify that "AIR BAG" warning light flashes 6 times and then turns OFF. If it does not operate as described, perform AIR BAG DIAGNOSTIC SYSTEM CHECK: ADVANCED AIR BAG .
scientia non olet · About LEMON Manuals