Part Inspection and Correction Table
WARNING: This page is about a different variant/trim than selected.
PART INSPECTION AND CORRECTION TABLE
| Part | Inspect for | Correction |
|---|---|---|
| Casted part, machined part | Small flaw, burr | Remove with oil stone |
| Deep or grooved flaw | Replace part | |
| Clogged fluid passage | Clean with air or wire | |
| Flaw on installing surface, residual gasket | Remove with oil stone or replace part | |
| Crack | Replace part | |
| Bearing | Unsmooth rotation | Replace |
| Streak, pitting, flaw, crack | Replace | |
| Bushing, thrust washer | Flaw, burr, wear, burning | Replace |
| Oil seal, gasket | Flawed or hardened seal ring | Replace |
| Worn seal ring on its periphery or side | Replace | |
| Piston seal ring, oil seal, gasket, etc. | Replace | |
| Gear | Flaw, burr | Replace |
| Worn gear tooth | Replace | |
| Splined part | Burr, flaw, torsion | Correct with oil stone or replace |
| Snap ring | Wear, flaw, distortion | Replace |
| No interference | Replace | |
| Thread | Burr | Replace |
| Damage | Replace | |
| Spring | Settling, sign of burning | Replace |
| Friction plate | Wear, burning, distortion, damaged claw | Replace |
| Separator plate, retaining plate | Wear, burning, distortion, damaged claw | Replace |
| Sealing surface (where lip contacts) | Flaw, rough surface, stepped wear, foreign material | Replace |