Enable Conditions
WARNING: This page is about a different variant/trim than selected.
ENABLE CONDITIONS
| Parameter | Minimum | Maximum |
|---|---|---|
| Battery voltage | 9 V | - |
| Engine speed | 400 rpm | - |
| Output shaft speed (calculated from input shaft speed) | 300 rpm | - |
| Shift position | "D", "3", "2" or "L" range | |
| Transmission range sensor | Normal condition or not monitored | |
| Input shaft speed sensor | Normal condition or not monitored | |
| Engine speed signal (U0100) | Normal condition or not monitored | |
| CAN communication (U0073) | Normal condition or not monitored | |