DTC Troubleshooting

WARNING: This page is about a different variant/trim than selected.

DTC TROUBLESHOOTING TABLE

Step	Action	YES	NO
1	Was "A/T System Check" performed?	Go to Step 2.	Go to A/T SYSTEM CHECK .
2	DTC check Is DTC P0962 or DTC P0963 detected?	Go to applicable DTC diag. flow.	Go to Step 3.
3	Check pressure control solenoid valve Turn ignition switch to OFF position. Disconnect connectors from TCM and transaxle (valve body harness connector). Check pressure control solenoid valve for resistance by referring to PRESSURE CONTROL SOLENOID VALVE INSPECTION . Is it in good condition?	Go to Step 4.	Replace pressure control solenoid valve.
4	Check pressure control solenoid valve circuit Check the following circuit for high resistance. Between "C06-2" terminal of TCM connector and "LT GRN/BLK" terminal of valve body harness connector. Between "C06-4" terminal of TCM connector and "GRY" terminal of valve body harness connector. Is each resistance 1 Ω or less?	Substitute a known-good TCM and recheck.	Intermittent trouble. Check for intermittent by referring to INTERMITTENT AND POOR CONNECTION INSPECTION .