DTC Troubleshooting

WARNING: This page is about a different variant/trim than selected.

DTC TROUBLESHOOTING TABLE

Step	Action	YES	NO
1	Was "A/T System Check" performed?	Go to Step 2.	Go to A/T SYSTEM CHECK .
2	Check input shaft speed sensor circuit Disconnect TCM connectors with ignition switch turned OFF. Check for proper connection to input shaft speed sensor at "C07-6" and "C07-16" terminals. If OK, check resistance of sensor circuit. Resistance of input shaft speed sensor circuit Between terminals "C07-6" and "C07-16" of disconnected harness side TCM connector: 344 - 516 Ω at 20°C (68°F) Between terminal "C07-6"/"C07-16" of disconnected harness side TCM connector and ground: No continuity Are they in good condition?	Go to Step 4.	Go to Step 3.
3	Check input shaft speed sensor Check input shaft speed sensor for resistance by referring to INPUT SHAFT SPEED SENSOR INSPECTION . Is it in good condition?	"BLK" or "WHT" circuit open or short.	Replace input shaft speed sensor.
4	Check visually input shaft speed sensor and forward and direct clutches drum using mirror for the following No damage No foreign material attached Correct installation Courtesy of SUZUKI OF AMERICA CORP. Are they in good condition?	Intermittent trouble or faulty TCM. Check for intermittent by referring to INTERMITTENT AND POOR CONNECTION INSPECTION . If OK, substitute a known-good TCM and recheck.	Clean, repair or replace.