LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 74 (Wipers/Washers) >> Diagnostic Information and Procedures >> Windshield Wipers Diagnosis >> Wipers Do Not Work On HI Speed, LO Speed OK
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Wipers Do Not Work On HI Speed, LO Speed OK

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.
WIPERS DO NOT WORK ON HI SPEED, LO SPEED OK - DIAGNOSIS PROCEDURE

Step Action Value(s) Yes No
1
  1. Turn the ignition ON.
  2. Turn the wiper switch to HI.
  3. Check voltage at the wiper motor connector terminal 5.

Is voltage equal to the specified value?		 11 - 14 V Go to Step 2 Go to Step 3
2 Replace the wiper motor.
Is the repair complete?		 - System OK -
3
  1. Disconnect the wiper switch.
  2. Turn the wiper switch to HI.
  3. Use an ohmmeter to check for continuity between wiper switch terminal A8 and A9.

Does the ohmmeter indicate the specified value?		 0 Ω Go to Step 5 Go to Step 4
4 Replace the wiper switch.
Is the repair complete?		 - System OK -
5 Repair the open circuit between wiper switch connector terminal A9 and wiper motor connector terminal 5.
Is the repair complete?		 - System OK -
scientia non olet · About LEMON Manuals