LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 74 (Wipers/Washers) >> Diagnostic Information and Procedures >> Windshield Washer Diagnosis >> Windshield Washer Inoperative, Wipers Work OK
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Windshield Washer Inoperative, Wipers Work OK

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.
WINDSHIELD WASHER INOPERATIVE, WIPERS WORK OK - DIAGNOSIS PROCEDURE

Step Action Value(s) Yes No
1 Activate the windshield washer switch.
Do the windshield wipers operate when the washer switch is activated?
- Go to Step 4 Go to Step 2
2
  1. Turn the ignition ON.
  2. While activating the washer switch, check the voltage at windshield wiper switch connector terminal A4.

Is voltage equal to the specified value?
11 - 14 V Go to Step 8 Go to Step 3
3 Replace windshield wiper switch.
Is the repair complete?
- System OK -
4 Check the windshield washer fluid reservoir.
Is there washer fluid in the fluid reservoir?
- Go to Step 6 Go to Step 5
5 Fill the windshield washer fluid reservoir.
Is the repair complete?
- System OK -
6 Check the windshield washer hoses and nozzles.
Are the windshield washer hoses and nozzies clogged or damaged?
- Go to Step 7 Go to Step 8
7 Repair the washer hoses and the nozzles.
Is the repair complete?
- System OK -
8
  1. Turn the ignition ON.
  2. With the windshield washer activated, check voltage at the windshield washer pump connector terminal;
    • 2 - NOTCHBACK
    • 1 - HATCHBACK, STATION WAGON

Is the voltage equal to the specified value?
11 - 14 V Go to Step 10 Go to Step 9
9 Repair open circuit between the windshield washer pump and the windshield wiper switch.
Is the repair complete?
- System OK -
10 Use an ohmmeter to measure resistance between ground and the windshield washer pump connector terminal;
1 - NOTCHBACK
2 - HATCHBACK, STATION WAGON
Is the resistance equal to the specified value?
∞ 0 Ω Go to Step 12 Go to Step 11
11 Repair the windshield washer pump ground circuit.
Is the repair complete?
- System OK -
12 Replace the windshield washer pump.
Is the repair complete?
- System OK -