Clutch Coil Removal and Installation: Installation
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.
- Place the clutch coil installer adapter J-33024 over the internal opening of the clutch coil housing and align the clutch coil installer adapter J-33024 with the compressor housing.
- Place the clutch coil installer adapter J-33024 over the internal opening of the clutch coil housing and align the clutch coil installer adapter J-33024 with the compressor housing.
- Center the puller crossbar J-8433-1 in the countersunk center hole of the clutch coil installer adapter J- 33024. Install the through-bolts of the compressor holding fixture J-34992 and the washers in the crossbar slots. Thread them into the holding fixture to the full thickness of the holding fixture.
- Turn the forcing screw J-8433-3, or use a suitable vise, to force the clutch coil onto the compressor housing.
- When the clutch coil is fully seated on the compressor housing, use a 3 mm (1/8 in.) diameter drift punch and stake the housing at three places, 120° apart, to ensure that the clutch coil will remain in position. Stake point size should be only one-half the area of the punch tip and approximately 0.28 - 0.35 mm (0.010 - 0.015 in.) deep.
- Install the clutch rotor and bearing assembly. Refer to Clutch Rotor and Bearing Disassembly and Installation .
- Install the clutch plate and hub assembly. Refer to Clutch Plate and Hub Assembly Disassembly and Assembly .
- Install the compressor. Refer to Condenser Removal and Installation .
- Connect the negative battery cable.
- Evacuate and recharge the A/C system. Refer to Discharging, Adding Oil, Evacuating, and Charging Procedures for A/C System .