LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Steering Wheel And Column) >> Repair Instructions >> Steering Wheel Speed Sensor Removal and Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Steering Wheel Speed Sensor Removal and Installation: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the upper and the lower instrument trim panels. Refer to INSTRUMENT CLUSTER TRIM PANEL REMOVAL AND INSTALLATION .
  3. Disconnect the steering wheel speed sensor electrical connector.
    Fig 1: Identifying Steering Wheel Speed Sensor Electrical Connector
    G04717640Courtesy of SUZUKI OF AMERICA CORP.
  4. Remove the intermediate shaft from the steering column to allow removal of the steering wheel speed sensor. Refer to INTERMEDIATE SHAFT AND DASH SEAL REMOVAL AND INSTALLATION .
  5. Remove the retaining screw from the steering wheel speed sensor.
  6. Remove the steering wheel speed sensor.
    Fig 2: Identifying Retaining Screw And Steering Wheel Speed Sensor
    G04717641Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals