Ignition Lock Cylinder and Switch Removal and Installation: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the upper and the lower steering column cover panel by removing the screws.

Fig 1: Identifying Upper And Lower Steering Column Cover Panel Screws
Courtesy of SUZUKI OF AMERICA CORP.
With the key in the ignition turned to the position designated ACC, remove the lock cylinder by pressing down the detent spring and pulling the lock cylinder out of the switch cylinder housing.

Fig 2: Removing Lock Cylinder By Pressing Down Detent Spring
Courtesy of SUZUKI OF AMERICA CORP.
Remove the ignition switch retaining screw.
Disconnect the wiring and remove the ignition switch.

Fig 3: Identifying Ignition Switch Retaining Screw And Wiring
Courtesy of SUZUKI OF AMERICA CORP.