Ignition Lock Cylinder and Switch Removal and Installation: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.

Install the ignition switch with the ignition switch retaining screw.
Tighten:

Tighten the ignition switch retaining screw to 2.5 N.m (22 lb-in).
Connect the wiring to the ignition switch.

Fig 1: Identifying Ignition Switch Retaining Screw And Wiring
Courtesy of SUZUKI OF AMERICA CORP.
Install the lock cylinder.
Install the upper and the lower steering column cover panel with the screws.
Tighten:

Tighten the upper and the lower steering column cover panel screws to 2.5 N.m (22 lb-in).
Connect the negative battery cable.

Fig 2: Identifying Upper And Lower Steering Column Cover Panel Screws
Courtesy of SUZUKI OF AMERICA CORP.