Key Cannot Be Removed in the Lock Position (Key Interlock System)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.
KEY CANNOT BE REMOVED IN LOCK POSITION (KEY INTERLOCK SYSTEM) - DIAGNOSTIC PROCEDURES
| Checks | Action |
|---|---|
| Check to see that the ignition switch is set correctly. | Reset the ignition switch. |
| Check the lock cylinder for damage. | Replace the lock cylinder. |
| Check the fuse F17 from the I/P fuse block. | Replace the fuse F17. |
| Check for an open or short in the circuit between terminal 2 of key interlock solenoid and the I/P fuse block. | Replace the fuse F17. |
| Select the gear shift lever to "P" position. Check the resistance between the terminal 2 and 1 of the "P" position switch. |
Replace the "P" position switch. |
| Check for an open or short in the circuit between the ground G202 and terminal 1 of the key interlock relay. | Replace the open or short from the circuit. |
| Turn the ignition ON. Select the gear shift lever to "P" position. Check the resistance between the terminal 1 and 2 of the key interlock solenoid. |
Replace the key interlock solenoid. |